[Tig] HD tape to tape

[Tim Stipan]

When you imported your edl was the the tc setting on auto or was it set to 24 fps?



Tim  



-----Original Message-----

From: "WB" <rickpags at yahoo.com>

To: tig at tig.colorist.org

Sent: 11/12/2007 2:12 PM

Subject: [Tig] HD tape to tape



Thanks to Glenn Chan for supporting the TIG.

 ====







     

          I am using a DaVinci 2k in HD tape to tape

going from HDcam to HDcam in df tc. I am using a

client supplied EDL which  is fine as far as all the

marks landing where they should although after you

read this you might think I'm a bit off. 

           Herein is my dilema. The marks are

"floating" if you will. One minute the marks land fine

and I go back and find that they are off by 1 to a few

frames.  So I go back and reset and check it and it's

off.  The deck is fine, the tape is fine. Last Friday

when I left the marks were landing where they should,

dead on and now they are not and there is no

consistency whatsoever.  And of course all this comes

at a time when I'm slammed to the wall. But then I

knew when I woke up this morning that Mercury was in

retrograde and that voice in my head was telling me to

just stay home....to honor the Vets, not b/c of the

Mercury thing.    Does anyone have even a hint of a

clue what's going on here besides a ghost in my

machine?!  



  Mucho thanks,

   Rick



__________________________________________________

Do You Yahoo!?

Tired of spam?  Yahoo! Mail has the best spam protection around 

http://mail.yahoo.com 



_______________________________________________

No personal abuse; absolutely no advertising or marketing on the main TIG mailinglist.  Emergency

tig contact address is rob (at) calarts.edu

Tig mailing list

Tig at tig.colorist.org

http://tig.colorist.org/mailman/listinfo/tig