[Tig] BNC to XLR? (Aaton Keylink Install Question)

[Michael Poimboeuf]

XLR standard AES wiring is pin2 hot (to bayonet of BNC) pin3 cold, and  
pin1 chassis/shield. Either use a transformer to galvanically isolate  
or just short 3 to 1 to BNC shield (if shorting causes ground loop  
buzz then you might have to pay for the transformer).

--
mkp at digidesign.com


On May 23, 2008, at 4:15 PM, Paul Korver <paul at cinelicious.tv> wrote:
...
> If the answer is making a cable does anyone know which of
> the three XLR pins the LTC signal is running on?